TTR Rear Sway Bar....

[M-Dub]

Originally Posted by Cruisn so what should i be looking for? to decide how messed up it really is? When I finished unbolting one side it dropped down almost 2.5 inches. then I tried to push it back into position to touch the bottom of the spring perch and I couldn't I got it to within 1" of the bottom of the spring seat then I wasn't strong enough to move it anymore... would that be putting a slight preload to one side? a few other pictures of there awesoem powdercoating: and I noticed this: to get that bracket to sit flat the other side of the sway bar is about 6-7 inches off the table. 4inches out. had my woman help so it was accurate. sitting flat on the table: the other side:

That is why they are so cheap!

[Cobalt Tom]

thank you for bringing this to the attention of this forum, and for all the members concerned about this know that the forum staff is discussing this.

[ls1fbody]

Admin, i just posted the same in the G5 Section, feel free to remove it as there is no need for two. Thanks

[Cobalt Tom]

Originally Posted by ls1fbody Admin, i just posted the same in the G5 Section, feel free to remove it as there is no need for two. Thanks

saw that :P

[M-Dub]

yeah either one didnt know he made one too

[Cobalt Tom]

Originally Posted by M-Dub yeah either one didnt know he made one too

hahaha, its all good, taken care of

[M-Dub]

Originally Posted by Cobalt Tom hahaha, its all good, taken care of

thank ya tom

[ls1fbody]

You're supposed to keep me in the loop dubbie!

[M-Dub]

shhhh im sorry hommie

[cobalt123]

ill keep this in mind as i have a TTR bar, actually its passed hands several times originated with steddy i finally bought it off of hunterkiller