You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Search results
-
B
Cylinder 1 Misfire, please help
It sounds like you have a weak valve spring at this point. The next step is to perform a cylinder leak down test on the cylinder that has the misfire. You have to remove the camshafts, or at least lift them up enough so the valves are all in the up position. Attach the pressure hose and gauge...- bockwoldt
- Post #36
- Forum: General Discussion
-
B
Cylinder 1 Misfire, please help
Here's a good article about the 2.2L motor and misfires Check Engine Light P0300 Misfire At Idle- 2.2L And 2.4L Are you having a rough idle or is it not really noticeable? Keep methodically working through the problem. Hopefully it's not a bad exhaust valve......- bockwoldt
- Post #27
- Forum: General Discussion
-
B
Cylinder 1 Misfire, please help
Try spraying some carburetor cleaner around the injector. If you hear the engine RPMs increase, or a sucking noise, replace the o-rings. If there is no leak, try moving the injector from cylinder 1 to cylinder 2. Make sure you're careful with the o-rings so they don't rip during the move. If the...- bockwoldt
- Post #25
- Forum: General Discussion
-
B
Cylinder 1 Misfire, please help
In cases of misfires these are main steps to follow: Move spark plug from another cylinder not having the misfire. If the misfire follows the cylinder, change the spark plugs. If the spark plug is good, then change the coli pack from another known good cylinder. If misfire follows, change the...- bockwoldt
- Post #19
- Forum: General Discussion
-
B
Transaxle bearings?? Loud roar
It sounds like your hub assembly. I had the same thing happen on my 2008 LT. Living in Chicago with a lot of snow and salt, the moisture got into the bearings and they started to go. You can find them on eBay for about $70 each. I replaced both at the same time. It's a fairly easy job. Pull...