Ya I diagnosed it a little bit over my spring break and realized that there is a 2amp fuse that was blown that powers the ignition switch. Obviously the vehicle functioned fine so I never thought to check for that. However even after changing that fuse I still had no success in getting it to...
Yes I am using the bypass module and it is working properly because I got it to remote start previous to finishing the installation. Is it possible that there is too much resistance in my connections from the remote start to the ignition module? When small gauge wire is used I know that it...
I am trying to install a Viper 5901 remote start on my 2010 cobalt. I have done this multiple times before and this is the first time I have run across small gauge wire at the ignition harness. I have all necessary wiring diagrams and even a wiring guide that best buy installers use. The guides...