2 new mods done today

[Cobalt08ls]

black cat custom gauge face.
the red leds will be installed monday. my installer needed a smaller soldering iron and didnt have one at the time

doorsil mod.

 

[outtamymind]

nice. lovin the doorsil mod. i can't remember how its done but still looks awesome.

 

[Cobalt08ls]

thanks.
yeah itook it to a shop to get done
i have to go back because when my doors are closed the dic says that there open.
there fore when i open my door the light doesn't go on and that is one feature i like about the dome light and need to get fixed.

 

[arman14]

nice
i like the gauges

 

[outtamymind]

hmm thats odd. is your door sills sitting pretty low or are they pretty high.

 

[dman090]

door seal looks awesome. i cant wait till i get mine in

 

[Cobalt08ls]

hmm thats odd. is your door sills sitting pretty low or are they pretty high.

just a crappy pic.

---------- Post added at 01:26 AM ---------- Previous post was at 01:25 AM ----------

nice
i like the gauges

thanks
the'll look 100 times better when the led's are installed

 

[outtamymind]

no i meant for the door not closing properly issue lol

 

[Cobalt08ls]

no i meant for the door not closing properly issue lol

idk it has something to do with the wiring
the doors both close fine
its something to do with the plunger that its wired to. im going to have to figure it out

 

[outtamymind]

ahh ok. did they put the grommet back in properly, might be causing the push switch not to fully close.

 

[Cobalt08ls]

im going to have to look at them tomorrow.

 

[outtamymind]

ya its probably something really simple

 

[Cobalt08ls]

yeah. so is the end of the grommet suppose to be seen through the hole by the end of the door.
like when i pull the carpet back what should i look for to make sure that everything is properly put back

 

[outtamymind]

how did they wire it up would help me help you figure it out.

 

[Cobalt08ls]

i have a full how to thats all printed out
but its based off this one by sweetsandman just more detailed and such
http://cobaltss.net/forums/showthread.php?t=27689&page=2

 

[outtamymind]

hmm after looking at that, i would say open the door and make sure there is nothing blocking the door, and if they spliced into the wiring harness there could be problems there. everything could have been avoided just by hooking up to the door's push switch. checking the wiring to make sure everything is hooked up snuggly and not touching.