You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Recent content by Radejr
-
R
Head Removal
I've been reading a lot about doing valve jobs and head removal, timing all that jazz. What I cannot find is what is all the parts/tools I may need. Is there any special tools? My parts list so far includes: Head Gasket Set, Timing Cover Gasket, Timing Chain, Head Bolts, Coolant, Oil. I'm...- Radejr
- Thread
- Replies: 0
- Forum: General Discussion
-
R
Misfire...now running lean? What?
I pulled my injectors out all those o rings are shot I think I screwed them up putting them back in.- Radejr
- Post #6
- Forum: LS, LT, LTZ
-
R
Misfire...now running lean? What?
Maybe I have caused the lean code to pop. So I used starting fluid spraying around hoses and what not. I could hear sucking around the fuel injectors. I sprayed that way and looks like my injectors are not seated well? I spray each one on each one I can almost choke the motor out. I moved some...- Radejr
- Post #5
- Forum: LS, LT, LTZ
-
R
Misfire...now running lean? What?
That's the one off the air box right? What's a safe way to clean it?- Radejr
- Post #3
- Forum: LS, LT, LTZ
-
R
Misfire...now running lean? What?
So I was getting cylinder 1 misfire did the typical trouble shooting wouldn't go away. My last ditch effort to not stop tearing down any part of the motor is let's run some Techron or Seafoam through it see what happens. Well I decided on Techron I added it to about 3/4 tano sloshed it around...- Radejr
- Thread
- Replies: 7
- Forum: LS, LT, LTZ
-
R
Cylinder 1 Misfire Still...
I have an 08 Cobalt 2.2 Ecotec. I started getting a check engine light. P0301 is the code. I replaced spark plugs with NGK plugs. Code came up again. Swapped Coils. Code Returned. I hit a deer in this process had to replace radiator. Ended up running over it. I got the code cleared and it...- Radejr
- Thread
- Replies: 1
- Forum: General Discussion
-
R
2008 chevy cobalt misfire #1
Have you figured it out? I had cylinder 1 misfire I started with new plugs the light came on again. I moved the coil pack about 4 days ago no light yet. Usually doesn't come in unless I let it idle for about 45 mins or drive it hard. So waiting for that light again see if it's coil.- Radejr
- Post #5
- Forum: LS, LT, LTZ