utsadude
Platinum Member
I need the pin out for the EV6 injector harness. As well as the pin out for the EV1 injector harness.
Anyone who is a GM tech able to help me out?
Anyone who is a GM tech able to help me out?
I need a favor
- Thread starter utsadude
- Start date
cobalt123
Platinum Member
jn2?
utsadude
Platinum Member
Good thinking. I'll text him.
interviewatruins
Member
its not too hard, what are you wondering about?
him and i did mine first on my build and we did his on his build later on.
i dont know that either of us will have this.
what we did for aftermarket harness was just took each pin out pin by pin and swapped them injector by injector.
that was the easiest way of doing it.
match injector 1 to injector one on the other harness and keep doing it till its all done.
utsadude
Platinum Member
I have some EV1 60s I need to put in down the road. I have the harness that came with them. Just need to know what to do.
interviewatruins
Member
i edited the post above btw.
you could also take your stock harness and just cut eat and solder it in if you don't want to take the time to take each pin out.
i think its easier to just pop each pin out carefully and literally place it where the other one is ...pin by pin. start off at injector one and then move to injector 4.
utsadude
Platinum Member
That's what I was thinking. Just had to be sure of it. It looks like there are quite a few more wires in the harness on the car now compared to the harness I got with the injectors.
BlackCobalt707
Full Access Member
ima be keeping an eye on this thread, i gotta do this soon
utsadude
Platinum Member
I'll post a how to when I do it. If I do it myself.
ff_drift_lol
Full Access Member
I'll get the info at work tomorrow.
interviewatruins
Member
i know with the 2.2s we have the map sensor attatched the stock stock harness.
thats why its got extra wires.
utsadude
Platinum Member
Thank you sir. 07 if that makes a difference.
ff_drift_lol
Full Access Member
http://dagostinoracing.com/index.php?main_page=product_info&products_id=9257¤cy=USD are you looking for something like this? i can still get you the pinout info but it sounds to me like you're trying to adapt the harness? that ones costly, but there are much cheaper alternatives.
utsadude
Platinum Member
That's exactly what I need. But I want to do it myself. Two wires go to the EV6s. Why can't I just take those two wires and splice the EV1 plug onto them?
interviewatruins
Member
ff_drift_lol
Full Access Member
yeah, it's a pretty simple task. just be sure to use solder and shrink wrap. you don't need a sudden injector failure...and then a burnt out cylinder.
utsadude
Platinum Member
Understood. I will definitely write up a how to when I do this.
ff_drift_lol
Full Access Member
good luck let us know how it goes
utsadude
Platinum Member
Will do. I won't be doing this for a while. But I'll let y'all know how it goes when I do.
