Back with a build.2.2 SC build thread.

Discussion in 'LS, LT, LTZ' started by FASTL61, Jun 24, 2012.

  1. FASTL61

    FASTL61 Platinum Member

    Age:
    36
    Posts:
    3,114
    Likes Received:
    0
    Joined:
    Jul 18, 2009
    Location:
    M-Town,AZ
    No cranks not out and I wont rev that high.I currently rev to 7300.Ill take it to 7500 and have 7800 IF I need it.
     
  2. BankDude

    BankDude Full Access Member

    Age:
    30
    Posts:
    384
    Likes Received:
    0
    Joined:
    Sep 29, 2010
    Just make sure your clearances are good on your bearings and you hone it to spec with the new rings...

    ---------- Post added at 06:06 PM ---------- Previous post was at 05:37 PM ----------

    Nvm you already did that haha. I cracked my crank and had to buy a new one. The crack wasn't noticeable by human eye so thats why I was concerned
     
  3. FASTL61

    FASTL61 Platinum Member

    Age:
    36
    Posts:
    3,114
    Likes Received:
    0
    Joined:
    Jul 18, 2009
    Location:
    M-Town,AZ
    head is torqued down and oil pan on.going to time it later today and button her up. :)
     

Share This Page